Installing The Library In A Rack - HP StoreEver MSL4048 Getting Started Manual

Installing the library in a rack

The library is installed easily into the HPE Standard Series Racks, HPE Enterprise Series Racks,
HPE Advanced Series Racks, HPE Rack System/E, and earlier generation HPE 9.5 mm
Square-Hole Racks. You need a #2 and a #3 Phillips screwdriver for this procedure.
Select the hardware packet for your rack
Packet label
7.1 mm Round-Hole Rack
9.5 mm Square-Hole Rack
Install the rails
1. Using the screws from the packet for your rack and a #3 Phillips screwdriver, secure the
front of one rail to the front of the rack. The support platform of each rail is tapered, narrowing
towards the rear.
2. Extend the rail to the depth of the rack and secure the rail to the back of the rack.
3. Repeat steps 1 and 2 to install the other rail.
4. Insert the clip nuts on the front of the rack in the locations shown. These will be used to
secure the library to the rack.
Applicable racks
HPE supported racks with 7.1 mm round holes in the rack column
HPE supported racks with 9.5 mm square holes in the rack column
1. Clip nut location
2. Rail screw location
3. Bottom of the library
4. U marker
Installing the library in a rack 13