Errdisable Recovery Cause Small-Frame - Cisco Catalyst 2960 Command Reference Manual

errdisable recovery cause small-frame

errdisable recovery cause small-frame
Use the errdisable recovery cause small-frame global configuration command on the switch stack or
on a standalone switch to enable the recovery timer for ports to be automatically re-enabled after they
are error disabled by the arrival of small frames. Use the no form of this command to return to the default
setting.
Syntax Description This command has no arguments or keywords.
Defaults
This feature is disabled.
Command Modes Global configuration
Command History Release
12.2(44)SE
Usage Guidelines This command enables the recovery timer for error-disabled ports. You configure the recovery time by
using the errdisable recovery interval interval interface configuration command.
Examples This example shows how to set the recovery timer:
Switch(config)# errdisable recovery cause small-frame
You can verify your setting by entering the show interfaces user EXEC command.
Related Commands Command
errdisable detect cause small-frame
show interfaces
small-frame violation rate
Catalyst 2960 Switch Command Reference
2-104
errdisable recovery cause small-frame
no errdisable recovery cause small-frame
Modification
This command was introduced.
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
Description
Allows any switch port to be put into the error-disabled
state if an incoming frame is smaller than the configured
minimum size and arrives at the specified rate (threshold).
Displays the interface settings on the switch, including
input and output flow control.
Configures the size for an incoming (small) frame to cause
a port to be put into the error-disabled state.
OL-8604-04