Intel® Server System S7000FC4UR TPS
Setup Item
Save as User Default
Values
Load User Default
Values
15.3 Loading BIOS Defaults
Different mechanisms exist for restoring the system configuration to default values. The BIOS
loads the default system configuration values during the next POST after the request is
received.
A user can restore the BIOS factory default configuration as follows::
The BIOS Setup Utility <F9> hotkey or Exit menu Load Default Values option
The main board NVRAM Clear jumper
Power down the system, but do not remove AC power.
-
Configure the NVRAM Clear jumper to enabled/clear CMOS, connecting pins 2 and
-
3.
Configure the NVRAM Clear jumper to default/normal mode, connecting pins 1 and
-
2.
Power on the system.
-
Note: The server system does not support any other mechanisms to clear NVRAM.
Revision 1.0
Options
Save current BIOS Setup
Utility values as custom user
default values. If needed, the
user default values can be
restored via the Load User
Default Values option below.
Note: Clearing CMOS or
NVRAM will cause the user
default values to be reset to
the factory default values.
Load user default values.
Help Text
User is prompted for
confirmation.
User is prompted for
confirmation.
BIOS User Interface
Comments
193