Initial Inspection - Barco Prometheus I Safety & Instruction Manual

2. General
2.4

Initial inspection

General
Before shipment, the projector was inspected and found to be free of mechanical and electrical defects. As soon as the projector is
unpacked, inspect for any damage that may have occurred in transit. Save all packing material until the inspection is completed. If
damage is found, file claim with carrier immediately. The Barco Sales and Service office should be notified as soon as possible.
The packaging of the Prometheus is provided with a shock-watch label. If this shock-watch label was trig-
gered (red colored at arrival) during transport, indicates that the package was possibly roughly handled by
the transport company. In this case, the instructions mentioned on the label, should be followed, which are:
adding a note on the "bill of lading" and informing the transport company and the Barco sales and service
office as soon as possible.
Box content
After unpacking the projector it is recommended to check if all following items where included:
• One short power link cable (mono phase) (in case no UPS is used) - Installed on projector.
• This manual (installation manual).
• Safety manual
The projector lens and xenon lamp are not included in the package of the projector.
Mechanical check
This check should confirm that there are no broken knobs or connectors, that the cabinet and panel surfaces are free of dents and
scratches, and that the operating panel is not scratched or cracked. The Barco Sales and Service office should be notified as soon
as possible if this is not the case.
Tamper labels
During installation please inspect the tamper labels, if they are damaged please contact Barco tech support.
The tamper labels are required by DCI to provide easy visual indication if the equipment was tampered with. The projectors are
tested and labeled for shipping to ensure that the system was not compromised before reaching the customers final destination.
These tamper labels can be found behind the input cover. See "Removal of the input cover", page 135.
20 R5905963 PROMETHEUS SERIES 09/03/2015