Removing A Hdd Form The Icmp - Barco Prometheus I Safety & Instruction Manual

7.8

Removing a HDD form the ICMP

In case the ICMP has to be returned to factory (e.g. for repair) the non defective HDDs should be removed and
kept.
How to remove a HDD ?
1. Switch off the projector.
Note: In case only one HDD fails it is allowed to hot swap the HDD. To replace multiple failed HDDs the power must be switched
off.
2. Moving the latch towards the left.
Image 7-9
3. Push the unlock button to open the handle.
Image 7-10
4. Pull the HDD out of its slot.
Image 7-11
To install the HDD see procedure "Installing a HDD into the ICMP", page 118.
R5905963 PROMETHEUS SERIES 09/03/2015
7. ICMP
117