Table of Contents
Advertisement
10
Image 4-36
2. Requires the xenon lamp an anode adapter?
Tip:
See supported xenon bulb lamps to know if your lamp requires an anode adapter.
If yes, install the appropriate lamp anode adapter on the anode of the xenon lamp. Fasten the set screw (reference 13 image 4-37)
of the anode adapter with a torque of 2.5Nm (1.84 lbf*ft). Use a torque wrench with a 2.5mm Allen socket. Make sure that there
is full contact between the adapter flat surface and the lamp base.
Image 4-37
If no, make sure that there is no anode adapter installed on the anode of the xenon lamp.
3. Install the anode wire lug (reference 7 image 4-38) on the anode socket of the Lamp House as illustrated. Use an open-end
wrench of 22 mm to hold the first nut (reference 5 image 4-38) while fastening the second nut (reference 9 image 4-38) with a
torque of 25Nm (18.4 lbf*ft) using a torque wrench. Ensure that there is a flat washer (reference 6 & 8 image 4-38) at both sides
of the wire lug (reference 7 image 4-38).
Warning:
A torque of 25Nm (18.4 lbf*ft) must be applied to fasten the nuts. Make sure that there is no tension on the anode
wire of the xenon lamp.
Note: Alter tightening the two nuts, the connector should still be "floating".
R5905963 PROMETHEUS SERIES 09/03/2015
9
2.5Nm
2.5Nm
13
4. Lamp & Lamp House
59
Advertisement
Table of Contents
