Initial Inspection; Hdx Flight Case - Barco HDX-4K20 FLEX User Manual

Installation preparations
3. Take out the foam rubber.
4. Take out the projector.
Save the original shipping cardboard box and packing material. They will be necessary if you ever
have to ship your projector. For maximum protection, repack your projector as it was originally
packed at the factory.
A rubber foam inside a plastic bag is placed into the lens opening of the projector. It's recommended
to reuse this foam and plastic back each time you transport the projector. This to prevent intrusion of
dust and foreign particles.
The lens is delivered in a separate box.

2.3 Initial inspection

General
Before shipment, the projector was inspected and found to be free of mechanical and electrical defects. As
soon as the projector is unpacked, inspect for any damage that may have occurred in transit. Save all packing
material until the inspection is completed. If damage is found, file claim with carrier immediately. The Barco
Sales and Service office should be notified as soon as possible.
The packaging of the HDX is provided with a shock-watch label. If this shock-watch label was
triggered (red colored at arrival) during transport, that indicates that the package was possibly
roughly handled by the transport company. In this case, the instructions mentioned on the label,
should be followed, which are: adding a note on the "bill of lading" and informing the transport
company and the Barco sales and service office as soon as possible.
Box content
After unpacking the projector it is recommended to check if all following items where included:
• Three power cords of 2.5 meter, one CEE (7), one NEMA L6-20P and one CH2–16P
• One Quick Start guide
• One Safety manual
• One Web site reference sheet
• One remote control unit (RCU)
• 2 batteries for the RCU.
One xenon lamp is mounted inside the lamp house at delivery. The projector lenses are not
included in the package of the projector.
Mechanical check
This check should confirm that there are no broken knobs or connectors, that the cabinet and panel surfaces
are free of dents and scratches, and that the operating panel is not scratched or cracked. The Barco Sales
and Service office should be notified as soon as possible if this is not the case.

2.4 HDX flight case

Introduction of the HDX flight case
The HDX flight case is designed to transport the HDX in a safe and secure manner. The four caster wheels,
provided with breaks, and the four handles make the HDX flight case easy to handle. The floor of the flight
case wagon is equipped with two small covered compartments to store the remote control and the rigging
clamps.
24 R5906070 /16 HDX 4K