Table of Contents
Advertisement
4. Lamp & Lamp House
Image 4-27
2. Install the anode wire lug (reference 6 image 4-28) upon the anode socket as illustrated. Use an 8mm Allen torque key set to
9Nm (6.64lbf*ft) to secure the bolt (reference 8 image 4-28). Place a flat washer (reference 7 image 4-28) between the bolt and
the wire lug.
Warning:
Make sure that there is no tension on the anode wire of the xenon lamp.
Image 4-28
Tip:
Write down the serial number of the xenon lamp. You will need this while updating the lamp parameters after installation
of the xenon lamp. The serial number of the xenon lamp is engraved in the neck of the xenon lamp.
3. Check the cathode connection inside the lamp house. Use an 22 mm open-end wrench to hold the first nut while fastening the
second nut on the rod with a torque of 25Nm (18.4 lbf*ft) using a torque wrench with 22 mm hexagon socket. Ensure that there
is a flat washer at both sides of the wire lug. It's safer to do this check before the xenon lamp is installed to avoid accidental
bumping against the xenon lamp.
Tip:
The cathode socket can easily pulled out from the Lamp House as a whole to perform this check.
Caution:
These cathode connections must be checked with every lamp change!
25 Nm
Image 4-29
54
9
2.5Nm
10
6
7
8
9Nm
R5905963 PROMETHEUS SERIES 09/03/2015
Advertisement
Table of Contents
