Mvr Robustness-Value - Edge-Core ECS4120-28F Reference Manual

mvr robustness-value

mvr source-port-
mode dynamic
This command configures the expected packet loss, and thereby the number of
times to generate report and group-specific queries. Use the no form to restore the
default setting.
Syntax
mvr robustness-value value
no mvr robustness-value
value - The robustness used for all interfaces. (Range: 1-255)
Default Setting
2
Command Mode
Global Configuration
Command Usage
◆
This command is used to set the number of times report messages are sent
upstream when changes are learned about downstream groups, and the
number of times group-specific queries are sent to downstream receiver ports.
◆
This command only takes effect when MVR proxy switching is enabled.
Example
Console(config)#mvr robustness-value 5
Console(config)#
Related Commands
mvr proxy-switching (703)
This command configures the switch to only forward multicast streams which the
source port has dynamically joined. Use the no form to restore the default setting.
Syntax
[no] mvr source-port-mode dynamic
Default Setting
Forwards all multicast streams which have been specified in a profile and bound to
a domain.
Command Mode
Global Configuration
Command Usage
◆
By default, the switch forwards any multicast streams within the address range
set by a profile, and bound to a domain. The multicast streams are sent to all
Chapter 24
– 705 –
| Multicast Filtering Commands
MVR for IPv4