Auto-Traffic-Control Control-Release - Edge-Core ECS4120-28F Reference Manual

auto-traffic-control
control-release
SNMP Trap Commands
snmp-server
enable port-traps atc
broadcast-alarm-clear
Example
Console(config)#auto-traffic-control broadcast auto-control-release interface
ethernet 1/1
Console(config)#
This command manually releases a control response.
Syntax
auto-traffic-control {broadcast | multicast} control-release
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
Command Mode
Privileged Exec
Command Usage
This command can be used to manually stop a control response of rate-limiting or
port shutdown any time after the specified action has been triggered.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#auto-traffic-control broadcast control-release
Console#(config-if)
This command sends a trap when broadcast traffic falls beneath the lower
threshold after a storm control response has been triggered. Use the no form to
disable this trap.
Syntax
[no] snmp-server enable port-traps atc broadcast-alarm-clear
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Chapter 15
– 469 –
| Congestion Control Commands
Automatic Traffic Control Commands