Mvr Robustness-Value - Edge-Core ECS4210-12P Reference Manual

mvr robustness-value

Example
The following example enable MVR proxy switching.
Console(config)#mvr proxy-switching
Console(config)#
Related Commands
mvr robustness-value (585)
This command configures the expected packet loss, and thereby the number of
times to generate report and group-specific queries. Use the no form to restore the
default setting.
Syntax
mvr robustness-value value
no mvr robustness-value
value - The robustness used for all interfaces. (Range: 1-255)
Default Setting
2
Command Mode
Global Configuration
Command Usage
◆
This command is used to set the number of times report messages are sent
upstream when changes are learned about downstream groups, and the
number of times group-specific queries are sent to downstream receiver ports.
◆
This command only takes effect when MVR proxy switching is enabled.
Example
Console(config)#mvr robustness-value 5
Console(config)#
Related Commands
mvr proxy-switching (584)
Chapter 22
– 585 –
| Multicast Filtering Commands
Multicast VLAN Registration