Table of Contents
Advertisement
Chapter 24
| Multicast Filtering Commands
MLD Snooping
ipv6 mld snooping
vlan static
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-26)
Default Setting
No static multicast router ports are configured.
Command Mode
Global Configuration
Command Usage
Depending on your network connections, MLD snooping may not always be able
to locate the MLD querier. Therefore, if the MLD querier is a known multicast router/
switch connected over the network to an interface (port or trunk) on the switch,
you can manually configure that interface to join all the current multicast groups.
Example
The following shows how to configure port 1 as a multicast router port within VLAN
1:
Console(config)#ipv6 mld snooping vlan 1 mrouter ethernet 1/1
Console(config)#
This command adds a port to an IPv6 multicast group. Use the no form to remove
the port.
Syntax
[no] ipv6 mld snooping vlan vlan-id static ipv6-address interface
vlan - VLAN ID (Range: 1-4094)
ipv6-address - An IPv6 address of a multicast group. (Format: X:X:X:X::X)
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-26)
Default Setting
None
– 684 –
Hide quick links:
Advertisement
Table of Contents
