Table of Contents
Advertisement
◆
The destination file name should not contain slashes (\ or /), and the maximum
length for file names is 32 characters for files on the switch or 127 characters for
files on the server. (Valid characters: A-Z, a-z, 0-9, ". " , "-")
◆
The switch supports only two operation code files, but the maximum number
of user-defined configuration files is 16.
◆
You can use "Factory_Default_Config.cfg" as the source to copy from the
factory default configuration file, but you cannot use it as the destination.
◆
To replace the startup configuration, you must use startup-config as the
destination.
◆
The Boot ROM and Loader cannot be uploaded or downloaded from the FTP/
TFTP server. You must follow the instructions in the release notes for new
firmware, or contact your distributor for help.
◆
For information on specifying an https-certificate, see "Replacing the Default
Secure-site Certificate" in the Web Management Guide. For information on
configuring the switch to use HTTPS for a secure connection, see the ip http
secure-server command.
◆
When logging into an FTP server, the interface prompts for a user name and
password configured on the remote server. Note that "anonymous" is set as the
default user name.
◆
The reload command will not be accepted during copy operations to flash
memory.
Example
The following example shows how to download new firmware from a TFTP server:
Console#copy tftp file
TFTP server ip address: 10.1.0.19
Choose file type:
1. config:
2. opcode: 2
Source file name: m360.bix
Destination file name: m360.bix
\Write to FLASH Programming.
-Write to FLASH finish.
Success.
Console#
The following example shows how to upload the configuration settings to a file on
the TFTP server:
Console#copy file tftp
Choose file type:
1. config:
2. opcode: 1
Source file name: startup
TFTP server ip address: 10.1.0.99
Chapter 4
– 123 –
| System Management Commands
File Management
Hide quick links:
Advertisement
Table of Contents
