Ip Igmp Snooping Vlan Query-Interval - Edge-Core ECS4120-28F Reference Manual

ip igmp snooping vlan
query-interval
ip igmp snooping vlan
query-resp-intvl
This command configures the interval between sending IGMP general queries. Use
the no form to restore the default.
Syntax
ip igmp snooping vlan vlan-id query-interval interval
no ip igmp snooping vlan vlan-id query-interval
vlan-id - VLAN ID (Range: 1-4094)
interval - The interval between sending IGMP general queries.
(Range: 2-31744 seconds)
Default Setting
125 seconds
Command Mode
Global Configuration
Command Usage
◆
An IGMP general query message is sent by the switch at the interval specified
by this command. When this message is received by downstream hosts, all
receivers build an IGMP report for the multicast groups they have joined.
◆
This command applies when the switch is serving as the querier
as a proxy host when IGMP snooping proxy reporting is enabled
Example
Console(config)#ip igmp snooping vlan 1 query-interval 150
Console(config)#
This command configures the maximum time the system waits for a response to
general queries. Use the no form to restore the default.
Syntax
ip igmp snooping vlan vlan-id query-resp-intvl interval
no ip igmp snooping vlan vlan-id query-resp-intvl
vlan-id - VLAN ID (Range: 1-4094)
interval - The maximum time the system waits for a response to general
queries. (Range: 10-31740 tenths of a second in multiples of 10)
Default Setting
100 (10 seconds)
Command Mode
Global Configuration
Chapter 24
– 655 –
| Multicast Filtering Commands
IGMP Snooping
(page 643), or
(page 642).