Erps - Edge-Core ECS4120-28F Reference Manual

6.
Enable ERPS: Before enabling a ring as described in the next step, first use the

erps

enabled or has been disabled with the
work.
7.
Enable an ERPS ring: Before an ERPS ring can work, it must be enabled using the
enable
APS messages will start flowing in the control VLAN, and normal traffic will
begin to flow in the data VLANs. To stop a ring, it can be disabled on any node
using the
8.
Display ERPS status information: Use the
general ERPS status information or detailed ERPS status information for a
specific ring.
erps
This command enables ERPS on the switch. Use the no form to disable this feature.
Syntax
[no] erps
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
ERPS must be enabled globally on the switch before it can enabled on an ERPS ring
using the
Example
Console(config)#erps
Console(config)#
Related Commands
enable (527)
erps domain
This command creates an ERPS ring and enters ERPS configuration mode for the
specified domain. Use the no form to delete a ring.
Syntax
[no] erps domain ring-name [id ring-id]
command to globally enable ERPS on the switch. If ERPS has not yet been
command. When configuration is completed and the ring enabled, R-
no enable command.
enable command.
ring-name - Name of a specific ERPS ring. (Range: 1-12 characters)
ring-id - ERPS ring identifier used in R-APS messages. (Range: 1-255)
– 525 –
Chapter 20
| ERPS Commands
no erps command, no ERPS rings will
show erps command to display