Dot1X Timeout Quiet-Period - Edge-Core ECS4120-28F Reference Manual

Chapter 8
| Authentication Commands
802.1X Port Authentication
dot1x timeout
quiet-period
dot1x timeout
re-authperiod
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x re-authentication
Console(config-if)#
Related Commands
dot1x timeout re-authperiod (262)
This command sets the time that a switch port waits after the maximum request
count (see page 259) has been exceeded before attempting to acquire a new client.
Use the no form to reset the default.
Syntax
dot1x timeout quiet-period seconds
no dot1x timeout quiet-period
seconds - The number of seconds. (Range: 1-65535)
Default
60 seconds
Command Mode
Interface Configuration
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout quiet-period 350
Console(config-if)#
This command sets the time period after which a connected client must be re-
authenticated. Use the no form of this command to reset the default.
Syntax
dot1x timeout re-authperiod seconds
no dot1x timeout re-authperiod
seconds - The number of seconds. (Range: 1-65535)
Default
3600 seconds
Command Mode
Interface Configuration
– 262 –