Table of Contents
Advertisement
Entering Commands
Keywords and
Arguments
Minimum
Abbreviation
Command
Completion
This section describes how to enter CLI commands.
A CLI command is a series of keywords and arguments. Keywords identify a
command, and arguments specify configuration parameters. For example, in the
command "show interfaces status ethernet 1/5, " show interfaces and status are
keywords, ethernet is an argument that specifies the interface type, and 1/5
specifies the unit/port.
You can enter commands as follows:
◆
To enter a simple command, enter the command keyword.
◆
To enter multiple commands, enter each command in the required order. For
example, to enable Privileged Exec command mode, and display the startup
configuration, enter:
Console>enable
Console#show startup-config
◆
To enter commands that require parameters, enter the required parameters
after the command keyword. For example, to set a password for the
administrator, enter:
Console(config)#username admin password 0 smith
The CLI will accept a minimum number of characters that uniquely identify a
command. For example, the command "configure" can be entered as con. If an
entry is ambiguous, the system will prompt for further input.
If you terminate input with a Tab key, the CLI will print the remaining characters of a
partial keyword up to the point of ambiguity. In the "logging history" example,
typing log followed by a tab will result in printing the command up to "logging. "
Chapter 2
– 75 –
| Using the Command Line Interface
Entering Commands
Hide quick links:
Advertisement
Table of Contents
