Table 16: Frame Size Commands; Fan-Speed Force-Full - Edge-Core ECS4120-28F Reference Manual

Chapter 4
| System Management Commands
Frame Size

fan-speed force-full

Frame Size
jumbo frame
This command sets all fans to full speed. Use the no form to reset the fans to normal
operating speed.
Syntax
[no] fan-speed force-full
Default Setting
Normal speed
Command Mode
Global Configuration
Example
Console(config)#fan-speed force-full
Console(config)#
This section describes commands used to configure the Ethernet frame size on the
switch.

Table 16: Frame Size Commands

Command
jumbo frame
This command enables support for Layer 2 jumbo frames for Gigabit and 10 Gigabit
Ethernet ports. Use the no form to disable it.
Syntax
[no] jumbo frame
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
◆
This switch provides more efficient throughput for large sequential data
transfers by supporting Layer 2 jumbo frames on Gigabit and 10 Gigabit
Ethernet ports or trunks of up to 10240 bytes. Compared to standard Ethernet
frames that run only up to 1.5 KB, using jumbo frames significantly reduces the
per-packet overhead required to process protocol encapsulation fields.
Function
Enables support for jumbo frames
– 118 –
Mode
GC