show ethernet cfm
maintenance-points
local
This command displays the maintenance points configured on this device.
Syntax
show ethernet cfm maintenance-points local
{mep [domain domain-name | interface interface | level level-id] | mip
[domain domain-name | level level-id]}
mep – Displays only local maintenance end points.
mip – Displays only local maintenance intermediate points.
domain-name – Domain name. (Range: 1-43 alphanumeric characters)
interface – Displays CFM status for the specified interface.
ethernet unit/port
unit - Unit identifier. (Range: 1-8)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-26)
level-id – Maintenance level for this domain. (Range: 0-7)
Default Setting
None
Command Mode
Privileged Exec
Command Usage
◆
Use the mep keyword with this command to display the MEPs configured on
this device as DSAPs through the
◆
Using the mip keyword with this command to display the MIPs generated on
this device by the CFM protocol when the mip-creation method is set to either
"default" or "explicit" by the
name
command.
Example
This example shows all MEPs configured on this device for maintenance domain rd.
Console#show ethernet cfm maintenance-points local mep
MPID MD Name
---- ---------------- ----- ------ ---- -------- --------- -----------------
1 rd
Console#
ethernet cfm mep
ethernet cfm domain
Level Direct VLAN Port
0 UP
1 Eth 1/ 1 Enabled
– 789 –
Chapter 26
| CFM Commands
Defining CFM Structures
command.
command or the
ma index
CC Status MAC Address
00-12-CF-3A-A8-C0