Replace Carrier Bushings - ENCAD 60e Service Manual

Novajet PROe Series Service Manual
Figures 3-4 and 3-5 shows the locations of all the connectors on the
MPCB and carrier board respectively. To remove the ribbon cables
from their connectors, lift the connector's ribbon locking mechanism
as shown in figure 3-6. To reattach, depress the locking mechanism
back into the locking position after inserting the ribbon cable end.

Replace Carrier Bushings

The carrier bushings are rated for approximately 1500 hours of
operational usage. Many factors including, but not limited to, hours/
day used, cleanliness of the slide shaft and general ambient environ-
ment make it impossible to calculate the average time that the
carrier bushings to last.
If not replaced, the wear on the bushings can result in erratic carrier
motion and/or carrier axis failures. It can even cause the cartridge
head height to become uneven.
To replace the carrier bushings, follow the procedures for Carrier
Bushing Replacement found in Chapter 5.
52 Maintenance
Figure 3-6. Ribbon Connector Locking Mechanism.