Remove Servo Motor - ENCAD 60e Service Manual

6. Reconnect the Power Supply to the AC Entry Module by
reattaching the quick disconnect connection. Push the quick
disconnect assembly behind the Power Supply Bracket and out
of sight.
7. Perform steps 1 through 14 of the Install the MPCB procedure
to install the MPCB.
8. Perform steps 4 through 10 of the Install the Left, Top, and
Right Covers procedure to install the Right and Top Covers.

Remove Servo Motor

1. Perform steps 1 through 9 of the Remove the Left, Top, and
Right Covers procedure to remove the Top and Right Covers.
2. Perform steps 3 through 13 of the Remove the MPCB (Main
Printed Circuit Board) procedure to disconnect all connectors
from the MPCB.
3. Reach between the Power Supply Bracket and the AC Entry
Module and carefully pull out the quick disconnect assembly
attaching the Power Supply input to the AC Entry Module.
Disconnect the Power Supply input from the AC Entry Module.
4. Using a #2 Phillips screwdriver, remove the screw securing the
ground strap from the MPCB to the side plate.
5. Using a #2 Phillips screwdriver, remove the four screws
securing the Power Supply Bracket to the Right Baseplate.
Remove the Power Supply Bracket.
NOTE
The following procedure will leave the MPCB and
Power Supply still attached to the Power Supply
Bracket. For this procedure there is no reason to re-
move these assemblies from the Power Supply Bracket.
Novajet PROe Series Service Manual
Assembly\Disassembly 111