Install The Media Take-Up And Feed Motors - ENCAD 60e Service Manual

Novajet PROe Series Service Manual

Install the Media Take-Up and Feed Motors

1. Using a #1 Phillips screwdriver, install the three screws,
washers, and lock washers that secures the motor to the motor
mount.
2. Install the motor gear to the motor. Secure with a C clamp.
3. Insert the motor, motor mount, and motor gear subassembly
into the back of the Cradle Idler. Tilt the subassembly slightly
while installing to align the motor gear with the opening on the
top of the Cradle Idler.
4. Screw in the screw and washer that secures the motor mount to
the Cradle Idler.
5. Attach the tension spring to the post on the Cradle Idler.
6. Position the Cradle Idler assembly in front of the hole in the leg
assembly. Attach the wire connectors to the motor (red to the
positive terminal, black to the negative terminal.)
7. Insert the Cradle Idler Assembly into the leg and secure with
four screws.
148 Assembly\Disassembly