Remove The Trailing Cable Assembly - ENCAD 60e Service Manual

f.
Service Station Sled.
2. To install a Service Station Wiper, press the new Wiper onto
the wiper support.
3. Position the Service Station inside the Right Cover and place
the left side of the Service Station into the Platen.
4. Push down on the right side of the Service Station until the
Service Station snaps into place.
5. Slide the Carrier Assembly to the right and back into the home
position.
6. Lower the Top Cover.

Remove the Trailing Cable Assembly

1. Perform steps 1 through 13 of the Remove the Left, Top, and
Right Covers procedures to remove the Left, Top and Right
Covers.
2. If you have not already removed the Carrier Assembly from
the Slide Shaft, you will need to perform Steps 3 through 7 of
the Removing the Carrier Assembly, Carrier Belt, and the
Frame Tensioner procedures in order to remove the
Electronics Cover and release the left end of the Trailing Cable
from the Carrier PCB.
3. Disconnect the Trailing Cable Assembly connector at the J6
location on the MPCB. Use the thumb and forefinger to pull
forward on the connector lock and remove the Trailing Cable
from the connector. See Figure 3-6 if necessary.
4. The Trailing Cable Assembly is secured to the Stabilizer
Bracket by two pieces of double sided tape. Remove the
Trailing Cable Assembly from the Stabilizer Bracket.
5. Remove the ferrite and the tape securing it to the Trailing
Cable.
Reattach the spring onto the post on the bottom of the
Novajet PROe Series Service Manual
Assembly\Disassembly 131