Power Feed And Take-Up Motor Winding Resistance Check - ENCAD 60e Service Manual

Power Feed and Take-Up Motor Winding
Resistance Check
1. Remove the feed and/or take-up roll from the printer.
2. Using Phillips screwdriver, remove the four screws that
3. Ease the cradle idler off of the leg enough to disconnect the
4. Using a standard ohmmeter or multimeter, measure
5. If the measurement is found to be unsatisfactory, replace
6. Perform the same procedure on the remaining motor.
Figure 3-9. Power Feed and Take-Up Motor.
secure the cradle idler from the right leg.
motor wires from the leg harness.
between the + and - connections on the motor. While
manually rotating the servo motor, monitor the readings on
the meter. The acceptable range is 25-40 ohms. Typically,
the reading is 29-36 ohms.
the motor.
Novajet PROe Series Service Manual
Maintenance 55