Install The Carrier Assembly, Carrier Belt, And The Frame Tensioner - ENCAD 60e Service Manual

Novajet PROe Series Service Manual
11. To disengage the Carrier Belt from the Belt Clamp, push the
Carrier Belt away from the left post of the Belt Clamp and
gently lift up until the bottom edge of the Carrier Belt clears
the top of the left post.
12. Push the Carrier Belt away from the right post of the Belt
Clamp and gently lift up to finish removing the Carrier Belt
from the Belt Clamp.
13. Place the Carrier Assembly in an ESD (antistatic) bag in
preparation for shipment to ENCAD for replacement or repair,
or if it is to be stored for repair at your facility.
Install the Carrier Assembly, Carrier Belt, and the
Frame Tensioner
1. To install the Belt onto the Carrier Assembly, the "bumps" on
the belt (where the ends of the belt are joined together to make
the belt continuous) must be positioned between the left and
right posts of the Belt Clamp. See Figure 5-14.
2. Slide the Carrier Belt between the right post and the middle
post and guide it down into the Belt Clamp. Then slide the
Carrier Belt between the left post and the middle post and
finish placing the Carrier Belt into the Belt Clamp.
3. Check the position of the Carrier Belt to make sure it matches
Figure 5-14.
4. Make sure the left end of the Trailing Cable extends out beyond
the left end of the Trailing Cable Support Assembly.
120 Assembly\Disassembly
Failure to use an approved antistatic bag for storage
or shipment may cause damage to the MPCB and af-
fect the Warranty.