Install The Media Take-Up And Feed Sensor Brackets And Sensors - ENCAD 60e Service Manual

Novajet PROe Series Service Manual
Figure 5-27. Media Take-Up and Feed Sensor Removal.
Install the Media Take-Up and Feed Sensor
Brackets and Sensors
1. Using a #2 Phillips screwdriver, install the two screws securing
the bracket to the leg assembly.
2. Insert the sensor into the hole on the sensor bracket, secure by
screwing on the plastic nut onto the front of the sensor.
3. Route the sensor wires to the back of the bracket and secure
the wires using two wire tie wraps.
4. Bringing the wire from under the bracket, attach the wire
connector to the leg harness plug. Push connector in until
firmly seated.
146 Assembly\Disassembly