Novajet PROe Series Service Manual
8. Install the Lower Drive Roller Assembly support brackets using
a #2 Phillips screwdriver.
9. Reinsert the Foam Block. Make sure that the Stepper Motor
and Fan(s) cables are exiting out of the back corner of the Foam
Block. See Figure 5-26. The Foam Block is positioned between
the Stepper Motor and the Servo Motor. Make sure it is not
tilted at an angle.
11. Reinsert the Service Station.
12. Reinstall the Right Sideplate using a #2 Phillips screwdriver.
Ensure that all cables from inside the Platen are exiting out of
the large hole in the Sideplate.
13. Reinstall the Power Supply Bracket using four screws and a #2
Phillips screwdriver.
144
Assembly\Disassembly
Figure 5-26. Inside Platen, Right Side.