Remove The Media Take-Up And Feed Sensor Brackets And Sensors - ENCAD 60e Service Manual

14. Perform steps 5 through 14 of the procedures to reconnect the
MPCB.
15. Reinstall the Left Baseplate using a #2 Phillips screwdriver.
16. Reinstall the Left Sideplate using a #2 Phillips screwdriver.
17. Perform steps 1 through 4 of the Install the Ink Delivery
System procedures to reinstall the Ink Delivery System.
18. Perform the Install Left, Top, and Right Covers procedures to
install the Left, Top, and Right Covers.
Remove the Media Take-Up and Feed Sensor
Brackets and Sensors
1. Remove all media and media rollers from the printer.
2. Disconnect the sensor leads from the printers leg assembly by
squeezing the sides of the connector to release the quick
disconnect latches.
3. With a pair of wire cutters, cut the wire tie wraps (see Figure
5-27) that is securing the sensor leads to the sensor bracket.
4. Remove the sensor by unscrewing the plastic nut off of the
front of the sensor. Pull the sensor out of the bracket.
5. Using a #2 Phillips screwdriver, remove the two screws
securing the bracket to the leg assembly.
NOTE
The sensors for the media Take-Up and Feed As-
sembly are identical, but the brackets that they mount
to have distinct differences. The top bracket has an
additional extended arm attached to help in direct-
ing the media from blocking the sensor's beam path.
Ensure that the bracket is being replaced with the
correct bracket.
Novajet PROe Series Service Manual
Assembly\Disassembly 145