Remove The Ink Delivery System - ENCAD 60e Service Manual

Novajet PROe Series Service Manual
10. Ensure that all cable endings are protruding through the cable
access hole in the Right Sideplate.
11. Reinstall the Power Supply Bracket (with assemblies) using four
screws.
12. Reconnect the grounding strap from the MPCB to the side
plate.
13. Reconnect the Power Supply to the AC Entry Module by
reattaching the quick disconnect connection. Push the quick
disconnect assembly behind the Power Supply Bracket and out
of sight.
14. Perform steps 5 through 13 of the Install the MPCB procedure
to reinsert the removed connections from the MPCB.
15. Perform steps 4 through 10 of the Install the Left, Top, and
Right Covers procedure to install the Right and Top Covers.

Remove the Ink Delivery System

1. Perform steps 1 through 3 and 10 through 13 of the Remove the
Left, Top, and Right Covers procedures to remove the Top and
Left Covers.
2. Remove the Foam Chain Shelf located inside the rear support
bracket.
3. Move the Carrier to the center of the Slide Shaft.
114 Assembly\Disassembly
The Foam Chain Shelf being removed in step 2 is only
on the PRO 60e printers.
NOTE