Install Servo Motor - ENCAD 60e Service Manual

14. Lower the motor to clear the pulley assembly from the platen
and carefully bring the motor out of the printer.

Install Servo Motor

1. Reinsert the Servo Motor under the Platen with the
connector facing the FRONT side of the Platen. Guide the
pulley up through the opening in the Platen.
2. Once the Servo Motor pulley is through the Platen, push up
on the Servo Motor and align the screw holes with the screw
hole openings.
3. Insert the front screw into the Servo Motor and tighten it
almost all the way.
4. Lift up gently and hold the right end of the Trailing Cable.
5. Insert the back screw into the Servo Motor and tighten it.
6. Tighten both screws on the Servo Motor to 15 in-lb of torque.
7. Depress the back of the Frame Tensioner and wrap the
Carrier Belt over the Servo Motor pulley. Make sure that the
guides on the inside of the belt are inserted in the pulley
grooves and that the belt is not twisted.
8. Move the Carrier Assembly back and forth to check the
Carrier Belt tension.
9. Reinstall the Right Sideplate with four screws and a #2
Phillips screwdriver. Press the side plate down and towards
the back of the printer before tightening. Torque to 15 in-lb.
Make sure the screw does not go into the motor at
an angle, and be careful not to strip the head of the
screw or to cause damage to the Encoder Strip.
Novajet PROe Series Service Manual
Assembly\Disassembly 113