ENCAD 60e Service Manual page 121

5. Slide the Carrier Assembly onto the left end of the Slide Shaft,
making sure that the Encoder Strip fits into the slot in the
Slider and the Encoder on the Carrier PCB. Guide the belt
while sliding the Carrier Assembly from left to right on the
Slide Shaft.
6. Move the Carrier Assembly to the left end of the Slide Shaft
and align the left bushing on the Carrier Assembly with the left
end of the Slide Shaft.
7. Insert the Strain Relief (with Trailing Cable) onto the Carrier
Assembly by sliding it onto the Strain Relief Support until it
snaps firmly into place. See Figure 5-13.
8. Place the Trailing Cable into the J1 connector lock on the
Carrier PCB. Make sure the silver fingers on the Trailing
Cable are fully inserted into the lock and slide both sides of the
connector lock shut at the same time.
9. Place the right side of the back of the Electronics Cover under
the Trailing Cable Support Assembly and gently press down on
the ends of the Electronics Cover until the latches snap into
the Carrier Assembly.
10. Slide the Carrier Assembly to about the middle of the Slide
Shaft and stretch out the Carrier Belt.
11. Insert the Carrier Belt into the Frame Tensioner so that the
belt extends about an inch past the Frame Tensioner.
12. Holding the Carrier Belt and Frame Tensioner, insert the Idler
Pulley Assembly into the loop of the belt. Make sure that the
side of the Idler Pulley Assembly with the thicker outer ring of
plastic is facing up. See Figure 5-13.
13. Once the Idler Pulley Assembly is in position, pinch the belt to
hold the Idler Pulley Assembly in place and pull it into the
Frame Tensioner so that the axle rests in the V-shaped groove
in the Frame Tensioner.
14. Insert the Compression Spring into the opening in the back of
the Frame Tensioner so that the end of the spring fits over the
post inside the opening.
Novajet PROe Series Service Manual
Assembly\Disassembly 121