Table of Contents
Advertisement
9. Perform the same procedure to replace the Right Support Bracket
bushing.
Replacing the Carriage Bushings
1. Remove the Top, Left and Right Covers following procedures outlined
earlier in this chapter.
2. Remove the Ink Delivery System and the Carriage Assembly following
procedures outlined earlier in this chapter to remove the Carriage
Assembly from the Slide Shaft.
3. Use a flat tip screwdriver to push up on the latch which holds the
Carriage bushing in place. See Figure 5-24.
4. Pull the Carriage bushing out of the Carriage.
5. Repeat these procedures for the other Carriage bushings.
Figure 5-24. Carriage Bushing Removal.
Assembly\Disassembly
NovaJet 800 Series Service Manual
5-39
Advertisement
Table of Contents
