Table of Contents
Advertisement
Novajet PROe Series Service Manual
6. Remove the Right Sideplate to gain access to the Servo Motor
by unscrewing the four screws securing it to the Platen.
7. Depress the back of the Frame Tensioner (see Figure 5-9) to
create slack in the Carrier Belt and slip it off of the Servo
Motor pulley.
8. Move the Carrier Belt to the left so it is out of the way of the
Servo Motor pulley.
9. Move the Carrier Assembly to the left end of the Slide Shaft.
10. Lift up gently and hold the right end of the Trailing Cable.
11. Using a #2 Phillips screwdriver, remove the back screw on the
Servo Motor. The screwdriver will be at a slight angle.
12. Lower the Trailing Cable back into place.
13. While holding the Servo Motor, remove the front screw on the
Servo Motor.
112
Assembly\Disassembly
Figure 5-9. Slacken Carrier Belt.
Be careful not to strip the head of the screw or to
cause damage to the Encoder Strip.
Advertisement
Table of Contents
