Install The Media Drying Fans - ENCAD 60e Service Manual

Novajet PROe Series Service Manual
the tabs on the filter housing to release the housing off the fan.
5. Remove the four bolts securing the back bracket (the one with
the positioning bolts on the bottom) to both of the side plates.
6. Pull the back bracket away from the fans to gain access to the
faulty fan. Carefully pull the fan away from the front bracket
until access is gained to reach the electrical connector.
7. Disconnect the connector to the fan.

Install the Media Drying Fans

1. Reconnect the electrical connection to the fan. Push the
connector and wires into the bracket so the fan can be seated
correctly on the bracket.
2. Carefully orient all the fans so that the back bracket can be
installed correctly. Secure the back bracket to the side plates.
3. Install the air filter and air filter housing.
4. Lay the entire assembly onto the support brackets on the
printer. Ensure that the cable connector is on the right side of
the printer as it is installed.
5. Reattach the positioning wingnut on the left side of the
assembly.
6. Attach the wire connector to the leg harness plug. Push
connector in until firmly seated.
150 Assembly\Disassembly