Install The Power Supply, Cooling Fan, And Ac Entry Module - ENCAD 60e Service Manual

Novajet PROe Series Service Manual
8. Using a 1/4" wrench or socket, disconnect the AC Entry Module
ground from the ground stud on the Right Baseplate.
9. Remove the AC Entry Module by pressing in on the securing
tabs until the module is released.
Install the Power Supply, Cooling Fan, and AC
Entry Module
To install the Cooling Fan and AC Entry Module:
1. Insert the AC Entry Module into the AC Entry Module hole on
the Right Baseplate from the back of the printer. Press in until
it snaps securely into place.
2. Attach the AC Entry Module ground connection to the
grounding stud on the Right Baseplate.
3. Hold the Cooling Fan into place while inserting the four bolts
into the assembly. Attach the four 1/4" nuts to the bolts to
secure Fan assembly. Torque to 4 in-lbs.
4. Reinstall the Power Supply Bracket using four screws.
5. Insert and hold the Power Supply into place while securing it
with four screws. Torque to 15 in-lbs.
110 Assembly\Disassembly
Figure 5-8. Cooling Fan/AC Entry Module Removal.