ENCAD 60e Service Manual page 138

Novajet PROe Series Service Manual
2. Route the Load Sensor wires through the four wire clamps on
the back part of the Y-Arm Bracket.
3. Install the Slide Shaft and two supports to the Y-Arm Assembly
using four screws. Torque to 8 in-lbs.
4. Insert the back compression spring onto the shaft of the pinch
roller and push the back of the shaft through the back of the Y-
Arm Assembly. Install the C clamp around the shaft of the
pinch roller.
5. While compressing the forward pinch roller spring with a
screwdriver (or other flat object), position the pinch roller onto
the Y-Arm Assembly until the forward spring is located under
the hole in the Slide Shaft. Release the spring and verify that
the spring enters the hole in the Slide Shaft and that no kinks
are present in the spring.
6. Perform steps 4 and 5 for all pinch rollers.
7. Using a #2 Phillips screwdriver, secure the Y-Arm Assembly to
the Platen using seven screws. Torque to 15 in-lbs.
8. Perform the Install the Stabilizer Bracket and Encoder Strip
procedures to install the Stabilizer Bracket and Encoder Strip.
9. Perform the Install the Carrier Assembly, Carrier Belt, and the
Frame Tensioner Procedures to install the Carrier Assembly,
Carrier Belt, and the Frame Tensioner.
10. Perform the Install the Trailing Cable Assembly procedures to
install the Trailing Cable Assembly.
11. Perform the Install the Ink Delivery System procedures to
install the Ink Delivery System.
12. Perform the Install the Left, Top, and Right Covers procedures
to install the Left, Top and Right Covers.
13. Perform the Head Height Adjustment procedures found in
Chapter 3 of this service manual.
138 Assembly\Disassembly