Novajet PROe Series Service Manual
6. Place the Carrier PCB in an ESD bag (antistatic bag) in
preparation for shipment to ENCAD for replacement or repair,
or if it is to be stored at your facility for repair.
Install the Carrier PCB
1. Put the tab on the left end of the Carrier PCB into the slot in
the left side of the Carrier Assembly. See Figure 5-15.
2. Ensure that no flex cables are underneath the Carrier PCB.
3. Push down the right end of the Carrier PCB until the latch
snaps into place.
4. Reattach all flex cables on the Carrier PCB.
5. Perform the Install the Carrier Assembly, Carrier Belt, and the
Frame Tensioner procedures to reinstall the Carrier Assembly.
Remove the Paper Sensor or the Encoder Sensor
1. Perform the Remove the Carrier Assembly, Carrier Belt, and
the Frame Tensioner procedures to remove the Carrier
Assembly from the Slide Shaft.
124
Assembly\Disassembly
Failure to use an approved antistatic bag for storage
or shipment may cause damage to the Carrier PCB
and affect the Warranty.