Install The Mpcb - ENCAD 60e Service Manual

Install the MPCB

1. Put on an ESD wrist strap.
2. Remove the MPCB from the ESD bag.
3. Align the MPCB so that the serial and parallel connections
protrude out of the back of the printer and that the screw holes
are aligned to the holes on the power supply bracket.
4. Using a #2 Phillips Torque Screwdriver, fasten the MPCB to the
power supply bracket with 8 in-lb of torque. Ensure that the
ground straps from the side plate and baseplate are secured to
the MPCB by the screw located beside the side plate nearest to
the parallel port.
5. Connect the Power Supply Cooling Fan connector to J8 on the
MPCB.
6. Connect and lock the Trailing Cable connector to J7 on the
MPCB.
7. Connect the Vacuum Fan 2 (PRO 60e only) connector to J6 on
the MPCB.
8. Connect the Vacuum Fan 1 connector to J5 on the MPCB.
9. Connect the Load Sensor connector to J4 on the MPCB.
10. Connect the Leg Harness connector to J3 on the MPCB.
11. Connect the Servo Motor connector to J2 on the MPCB.
12. Connect the Stepper Motor connector to J1 on the MPCB.
Integrated circuits may become weakened or damaged
by electrical discharge. Do not touch or work near
integrated circuits without wearing an ESD wrist strap.
Novajet PROe Series Service Manual
Assembly\Disassembly 107