Codan 2110 series Reference Manual page 473

Table 70:
Error message
ERROR: No channels
found
ERROR: No GPS unit
connected
ERROR: No key at this
index
ERROR: No link
available
ERROR: No modes
programmed
ERROR: No modes with
this sideband
ERROR: No network for
selfid
ERROR: No networks
found
ERROR: No response from
RF unit
ERROR: No selfid
ERROR: No selfid for
network
Manpack Transceiver 2110 series Reference Manual
CICS error messages (cont.)
Description
You have made a call on the currently selected channel (scan is off),
but a channel cannot be selected because no channels are
programmed or you were in free tune (see
transceiver in free tune and Amateur
required. Program some channels into your transceiver, or if not
permitted to do so, contact your Codan representative.
You have sent GPS information in a call, however, the transceiver has
detected that a GPS unit is not connected in the system. Check the
cable connections to the GPS unit and that the RS232 Mode and
Speed entries in the Control List are set correctly. Option GPS Enable
must also be installed.
You have selected a secure index that does not have a secure key.
Select another secure index, or program a CES secure key or AES
secure key for this secure index.
There is no link available to the addressed station. This is caused by
updates occurring in the transceiver unit. Wait a few minutes for the
link to be established. If the link is still unavailable, try the call again.
No modes are programmed in the transceiver. Contact your Codan
representative.
No modes are programmed with this sideband. Contact your Codan
representative.
The command entered included a self address for which there is no
suitable network, for example, the self address contained alpha
characters but there is no ALE/CALM network.
You have set the transceiver to scan or are making a call while
scanning is on, but the transceiver cannot find any networks that are
set to be scanned. Change the Scan Network setting in each network
that you want to scan (see
There has been a problem making the call or requesting PTT such that
there is no response from the transceiver unit. Check cable
connections. Wait for a minute or two for the transceiver unit to
recover automatically.
You have made a call on the currently selected channel (scan is off)
without specifying a network. The transceiver has located a network
containing the channel, but no self address is set for this network.
Select a different channel, select a self address to use with the
network, or specify a network that has a valid self address in the call
information.
The specified network does not have a self address. Check the
command syntax and the self address list.
Operating the transceiver from a computer
page 331, Using the
Mode). Exit free tune if
page 151, Programming the Network List).
457