Codan 2110 series Reference Manual page 249

Table 31:
Name of entry
Cfg Incoming Msg
Cfg LBT Data
Sensitivity
Cfg LBT Mode
Cfg LBT Period
Cfg LBT Waveforms Set the waveform that LBT monitors.
Cfg Low Current
Mode
Manpack Transceiver 2110 series Reference Manual
Entries in the Control List (cont.)
Use this entry to...
Set whether or not the transceiver displays a message to the
operator when it is received.
If you want to:
• display messages and log them in the Calls In Log, select
Show and log
• prevent messages from being displayed, but still log them in
the Calls In Log, select Just log
Set the level of sensitivity to reduce false or weak detection of data
signals when LBT is active.
You may set the sensitivity level between –0.5 to +0.5 in steps of
0.002.
Set whether or not the transceiver listens for calls and traffic on a
channel before initiating a call.
If you want to:
• use LBT for every call, select Enabled
• use LBT, with the option to override for every call, select
Override allowed
disable LBT for all calls, select Disabled
•
For more information on listening before transmitting see
page 202, Listen Before Transmit
Set the length of time that the transceiver listens for calls and
traffic on a channel before initiating a call.
If you want to monitor:
• voice calls made using a Voice Only call system, or any call to
another station made using a Codan Selcall or ALE/CALM
call system, select Voice and calls
• voice calls made using a Voice Only call system, any call to
another station made using a Codan Selcall or ALE/CALM
call system, or any calls made via a data modem, select
Voice, calls and data
Set the level of current used by the transceiver during muted
operation.
If you want to:
• extend the time remaining for your battery, select Auto
• reduce the time remaining for your battery and improve the
receiver's performance in areas of high off-channel signal
levels, select Disabled
Mode.
The Control List
Default
Show and log
0
Override
allowed
2 seconds
Voice and
calls
Auto
233