Codan 2110 series Reference Manual page 389

Table 53:
Message
Key <name of key>
is stuck
Link quality
<progress of clearing action>
List is full
Locked entry
Locked list
Locked setting
Low battery
Low battery
<period of time> remaining
Low battery
recovered
Low Power Only
Macro error:
recreate macro for <name of
macro>
Macro memory
is full
Macro update needed
Delete a few unused macros
to make room for new
macros
Macros updated
Reload Keypad List in NSP
and save a new profile for
use with version <firmware
version> and higher
Manpack Transceiver 2110 series Reference Manual
System messages (cont.)
Description
A key on the front panel is stuck down. Release the key.
You have selected to clear the ALE link quality analysis information
from the transceiver and the progress of the clearing activity is
displayed.
You have attempted to create an entry or add an item to a list that is
full. Delete some entries/items.
You have attempted to edit a locked list, entry or setting. If the item
was locked at the same access level in which you are currently
logged, or at a lower level, you can unlock the item using the Unlock?
entry in the List Manager.
For example, if an entry was locked at user level and you logged in as
a user, you can unlock the entry (see
information).
Battery voltage is very low. Recharge or replace the battery. If the
transceiver is installed in a vehicle, start the vehicle to recharge the
battery.
The battery pack attached to the transceiver has detected that the
charge remaining in the battery is low. Replace the battery pack with
one that is fully charged, or recharge the battery pack.
The previous low battery condition for the battery is resolved.
You have attempted to change the transmit power level to one that is
not permitted for the frequency selected, for example, a CB
frequency.
An error occurred when the transceiver tried to create the macro.
Create the macro again.
The memory storage for macros is full. You must delete one or more
macros before you can create another.
The macros programmed through NSP are inconsistent with the
current version of transceiver unit firmware, and the transceiver has
insufficient memory space to update the macros. Delete one or two
macros then switch the transceiver off then on again.
NSP has downloaded an old set of macros that are inconsistent with
the current version of transceiver unit firmware. Load the new
Keypad List from the transceiver into a new profile for use with this
version of transceiver unit firmware and higher.
System messages
page 133, Locking and unlocking
373