Codan 2110 series Reference Manual page 425

A typical use for the variable expansion feature is as follows:
Command typed at initiating station
alecall BH "My position is
$GPS"
alecall B? +lqa "My
position is $GPS+"
Sending and receiving calls
When you make calls using CICS commands, you do not need to use the hangup
command when you are making successive calls, or using the chan or scan
commands. For example, after sending a gpsbeacon command, CICS enables you to
change the channel, then send another gpsbeacon command, without using the
hangup command to close the existing link.
CAUTION
Responses and outputs
CICS is an interface from which random outputs occur, for example, when calls are
received. Additionally, depending on the configuration of the equipment, the order of
responses to commands may change. Software operating on this interface must be able to
adapt to these irregularities to enable correct system behaviour under all conditions. It is
recommended that echo is switched off to avoid intermixing of the commands you enter
with the responses from the system (see
Message length in a Message call
The permitted message length when making a Message call depends on the type of call
system, the privacy mode selected, and the character set (see
command).
Manpack Transceiver 2110 series Reference Manual
If a response is not received to a gpsbeacon, gpsposition, or
pagecall command (for example, a page call ack to a
pagecall command), you must use the hangup, chan, scan or
call command to receive subsequent calls. Control software using these
commands must take this into account.
Operating the transceiver from a computer
Information displayed at receiving
station
ALE-LINK:
M2, BH, 05/02 02:13, "My
position is 8958.04N
13841.23E"
LQA: 'Ch 27980', M2, 0/29, -
/-, 100%
ALE-LINK:
M2, B?, 05/02 02:23, "My
position is 8958.04N
13841.23E +0.0M 101622 (A)"
page 422, echo command).
page 430, pagecall
'Ch 27980',
'Ch 27980',
409