Codan 2110 series Reference Manual page 394

System messages
Table 53:
Message
Receive-only
channel
Reply: <caller address>
<message>
Response by:
<list of NET members who
responded, latest response first>
Secure error:
hardware fault
Secure error:
index key not set
Secure error:
no keys set
Secure error:
try again
Service option
enabled
Settings
hidden in <name of entry>
Skip message
Only ALE/CALM allows
message with Selective calls
Sounding
completed
Status rcvd:
<Get Status information>
Status rcvd:
Request queued. Please wait
Synthesiser
lock error
378
System messages (cont.)
Description
You have attempted to transmit on a receive-only channel. Select a
channel on which you can transmit.
You have received a response to a call from another station. The
response includes a message.
You have made a NET call and received a slotted response from the
NET members listed.
The transceiver has detected an error in the voice encryptor hardware.
Switch off the transceiver, check that the cables are connected
correctly, then switch on the transceiver. If the problem persists,
contact your Codan representative.
You have selected a secure index that does not contain a CES secure
key or an AES secure key.
No CES secure keys or AES secure keys have been programmed
since the encryptor was installed. Program a CES secure key or an
AES secure key (see
secure index or page 297, Creating a secure key in a secure index
respectively).
The voice encryptor module has reset unexpectedly. Press SEC to
enter secure mode.
The service option in the transceiver is enabled. Contact your Codan
representative to have this option disabled.
You have attempted to display the settings for an entry where all the
settings have been hidden at user level.
To display the settings, use the Full view? entry in the List Manager.
To display the settings in normal view, use the Show? entry in the List
Manager.
The ALE Selective Msg entry in the Control List is enabled. You have
entered a message at the
to make the call on a network that is not ALE/CALM. The Selective
call will proceed without the message. If you want to send the
message, select an ALE/CALM network when prompted.
The sounding operation that you initiated from the front panel is now
complete.
The transceiver has received the Get Status information from the
station you called.
The remote transceiver has received the Get Status call and is
preparing the response.
The frequency synthesiser has not locked on a frequency. Contact
your Codan representative.
page 277, Creating a secure key in a Corporate
prompt in a Selective call and attempted
Manpack Transceiver 2110 series Reference Manual