Link Command; Lock Command - Codan 2110 series Reference Manual

link command

If you have the MIL-STD-188-141B ALE option installed, you can use the link
command to display the current link status of the transceiver.
Syntax
link
where:
link displays the current link status of the system.

lock command

Use the lock command to:
•
•
•
When a lock is on the transceiver, it only responds to the interface issuing the command,
that is, CICS. When more than one lock is on, a single lock off command releases the
entire system.
Syntax
lock
lock on
lock off
lock abort|break|steal
where:
lock displays the current lock state of the system.
on attempts to lock the system.
off releases the lock(s) on the system.
abort attempts to break a lock from another interface.
break releases this lock or another device's lock.
steal overrides normal locks, but not Emergency calls.
Manpack Transceiver 2110 series Reference Manual
display the current lock status of the transceiver
set whether or not the transceiver is locked
break or steal a lock from another interface
Operating the transceiver from a computer
427