Codan 2110 series Reference Manual page 390

System messages
Table 53:
Message
Memory error:
Address List reset
Memory error:
all lists reset
Memory error:
Calls In Log reset
Memory error:
Calls Out Log reset
Memory error:
Keypad List reset
Memory error:
macros reset
Memory error:
one or more lists reset
Memory error:
Phone Link List reset
Memory error:
station addresses reset
Memory error:
write failed
Modem Info:
Connected|Disconnect|
Timeout|No Response
374
System messages (cont.)
Description
The Address List has been reset to its factory-default contents due to a
memory error. If you created any entries in this list you must re-create
them, as required, or reload the profile into the transceiver using NSP.
Firmware in the transceiver has been upgraded. As the layout of data
in each list has changed from the previous version of firmware, all
lists have been reset to their factory-default contents. Re-create the
entries and/or re-enter the values in each list, as required, or reload the
profile into the transceiver using NSP.
The entries in the Calls In Log have been deleted due to a memory
error.
The entries in the Calls Out Log have been deleted due to a memory
error.
The Keypad List has been reset to its factory-default contents due to a
memory error. If you created any macros or modified any key
assignments you must re-create and/or re-enter them, as required, or
reload the profile into the transceiver using NSP.
The macro database has been reset to its factory-default contents due
to a memory error. If you created any macros you must re-create
them, as required, or reload the profile into the transceiver using NSP.
Firmware in the transceiver has been upgraded. As the layout of data
in some lists has changed from the previous version of firmware,
some lists have been reset to their factory-default contents. Re-create
the entries and/or re-enter the values in each list, as required, or reload
the profile into the transceiver using NSP.
The Phone Link List has been reset to its factory-default contents due
to a memory error. If you created any entries in this list you must re-
create them, as required, or reload the profile into the transceiver
using NSP.
Your station self addresses have been reset due to a memory error. Re-
enter these self addresses, as required, or reload the profile into the
transceiver using NSP.
An error occurred when the transceiver tried to write to non-volatile
memory. Retry the task that caused the error. If the problem persists,
contact your Codan representative.
An RM50 HF Data Modem has been detected, disconnected, become
inactive due to no activity within a timeframe, or is not responding.
Manpack Transceiver 2110 series Reference Manual