Selbeacon Command - Codan 2110 series Reference Manual

Operating the transceiver from a computer

selbeacon command

Use the selbeacon command to test the quality of a selected channel before you use it
to transmit voice or data. The command sends a request to the station you want to call on
the channel you have selected. This receiving station automatically responds with an
audible test signal. The volume and clarity of the returned signal indicates the quality of
the channel.
NOTE
Syntax
NOTE
selbeacon <address of called station>[@<network>] [s] [from
<self address>[@<network>]]
where:
<address of called station>[@<network>] is the address [and network] of
the station you want to call.
s makes the call in Silent Mode.
from <self address>[@<network>] is the self address [and network] you want
to use for this call.
436
You cannot use the ALL, ANY, Group Selective, NET, or Wildcard
address syntax with a selbeacon command.
For more information on address syntaxes see
commands.
page 406, Addresses in
Manpack Transceiver 2110 series Reference Manual