Codan 2110 series Reference Manual page 385

Table 53:
Message
Call type
not installed: <call type icon>
Call warning:
Message has been truncated
to <maximum length for call
system> characters
Calling...
<call type icon> <address>
Calling...
Send message
Call trying <name of channel>/
<name of mode>
Can't charge
...Too hot
Can't change
frequency
Can't change
mode
Can't change
mode: channel has changed
Can't change
mode: tcvr is scanning
Can't clarify
chan: tcvr is scanning
Manpack Transceiver 2110 series Reference Manual
System messages (cont.)
Description
The option to make this type of call has not been installed in the
transceiver. Select a different call type or, if you know the option code
for the call type, enter it using the Option code setting under the
Devices entry in the Control List (see
in the transceiver).
The message sent with the call is too long for the selected calling
system. The transceiver has truncated the message to the maximum
permitted for the calling system.
Your call has started. Wait for the next message.
You are sending a message within an existing ALE link to the in-link
address.
You have started a call in an ALE/CALM network. The transceiver is
attempting to make the call on the channel/mode displayed.
The battery monitoring system has detected that the temperature is
too high for charging. Wait until the battery temperature lowers, then
try charging the battery again.
You cannot edit frequencies in this transceiver.
You cannot change the mode on the current channel for one of the
following reasons:
• The mode you want to set is not an allowed mode for the channel.
Select another mode.
• The channel/mode is locked. You may be able to unlock it if you
are logged in at the same level.
• The TxD option is installed in the transceiver which prevents you
from changing modes on transmit channels. For more
information contact your system administrator.
The channel has been reprogrammed and the mode is no longer valid.
You cannot change the current mode because the transceiver is
scanning. Press SCAN to stop scanning, then try again.
You cannot use the clarifier while the transceiver is scanning. Press
SCAN to stop scanning, then try again.
System messages
page 253, Installing an option
369