Setting Up Cics - Codan 2110 series Reference Manual

Setting up CICS

Connecting a computer to a transceiver
To connect a computer to a transceiver:
1
Setting up a transceiver for CICS
To set up a transceiver to be used with CICS:
1
CAUTION
Setting up a computer for CICS
To set up a computer for use with CICS:
1
1
Manpack Transceiver 2110 series Reference Manual
Connect a serial port (for example, COM1) on the computer to the 19-way GPIO
connector on the front panel using cable 08-06237-001.
Make sure that the Control List settings for the serial port have been set correctly.
Check that:
• the corresponding RS232 Mode entry is set to CICS
• the corresponding RS232 Speed entry is set to the same rate as the computer
If you change the settings in these entries you must switch your
transceiver off then on again for the changes to take effect.
Start a terminal-emulation program.
Check the settings in the terminal-emulation program. Make sure that you:
• select the serial port on the computer that is connected to the serial port on the
transceiver
• select the data rate that corresponds to the data rate set in the Control List of the
transceiver
• set data bits to 8
• set parity to none
• set stop bits to 1
Operating the transceiver from a computer
411