Remove Front Cover And Interlock Switch - Christie Captiva DHD400S Service Manual

6. Remove four screws securing DMD chip and DMD board. Rotate the screw 180° counterclockwise
to separate DMD chip and DMD board. (Note: This steps need to be carried out in a clean-room
environment.)
7. The engine module is complete.

Remove Front Cover and Interlock Switch

1. Remove four screws and unplug one connector securing LVPS bracket. Note: The interlock switch
need to through the hole of the LVPS bracket (as red sequare).
2. Remove one screw and two hex screws securing the front cover module. Then remove two
screws and tear off mylar to separate interlock switch, front IR sensor board and front cover.
Captiva Service Manual
020-000867-03 Rev. 1 (05-2018)
Parts and Module Replacement
DMD Chip
Interlock Switch
Front IR Sensor Board
DMD Board
LVPS bracket
Front Cover
38