Parametric Coefficient Setting - Konica Minolta CM-M6 Instruction Manual

Parametric Coefficient Setting

… „
Specify the parametric coefficient used for pass/fail judgment of measured data for each target color.
Parametric coefficients can be edited only when the difference equation is "CMC", "ΔE*94", or "ΔE00".
Memo
Operating Procedure
1
Use [] or [] to move the cursor to "Parametric
coef.", and then press the [Confirmation] key.
The <Parametric coef.> screen is displayed.
2
Use [] or [] to move the cursor to the item to be
set, and then press the [Confirmation] key.
The <Parametric coef.> edit screen is displayed.
3
Use [] or [] to move the cursor to the item to set
and press the [Confirmation] key to change the
item.
• Pressing the [Confirmation] key causes the cursor to
appear on the value. Press [] or [] to change the
value. Move the cursor between the digits of the value by
pressing [] or [].
Settings
0.01 to 30.00
{ „
• Press the [Confirmation] key to confirm every time the
setting of an item is changed.
4
After all settings have been configured, use []/
[] or []/[] to move the cursor to "OK", and
then press the [Confirmation] key.
The setting is confirmed and the screen returns to the
<Parametric coef.> screen.
If [ESC] is pressed during setup, the settings will not be
Notes
changed and the screen will return to the <Parametric
coef.> screen.
5
Press [ESC] to return to the <Pass/Fail> screen.
57
Start the procedure from the <Target menu> - <Pass/Fail> screen.
Target
Target menu [0002]
Pass/Fail
Edit tolerance
Warning level
80%
Parametric coef.
Target
0002
TARGET-2
Parametric coef.
l (CMC) c (CMC)
1.00 1.00
-15°
2.00 1.00
15°
1.00 1.00
25°
1.00 1.00
45°
1.00 1.00
75°
1.00 1.00
110°
Target
0002
TARGET-2
Edit tolerance
Parametric coef.
-15°
l (CMC) c (CMC)
1.00 1.00
-15°
2.00
l (CMC):
2.00 1.00
15°
1.00
c (CMC):
1.00 1.00
25°
1.00 1.00
45°
1.00 1.00
75°
1.00 1.00
OK Cancel
110°